What are the troubleshooting and maintenance methods of automatic strander?

Automatic wire strander is a device often used in the production of wire and cable, which is used to combine multiple thin wires or twisted wires into one thick wire or twisted wire. In the process of use, there may be some faults, which need to be eliminated and repaired in time. The following is the automatic strander common fault elimination and maintenance methods.

First, power supply troubleshooting and maintenance

Unable to start: check whether the power socket is normal and confirm whether the power required by the strander is connected; Check whether the power switch is on, and check whether the switch is normal; Check whether the power cable is damaged or in poor contact. If it is damaged or in poor contact, replace or repair it in time.

Strander suddenly stops: check whether the power supply is interrupted and confirm whether the power cable is plugged tightly; Check whether the circuit breaker and fuse are blown. If so, replace them in time.

Second, transmission system troubleshooting and maintenance

The strander can not rotate normally after starting: check whether the motor works normally and confirm whether the motor is connected to the power supply; Check whether the motor drive belt is damaged or loose, if there is damage or loose, timely replacement or adjustment.

Unstable speed: check whether the driving device is normal and confirm whether the driving device is running smoothly; Check whether the belt is loose or damaged. If it is loose or damaged, adjust or replace it in time.

Third, wire and reel system troubleshooting and maintenance

The wire reel cannot send wires automatically or the wire is not smooth. Check whether the wire reel is stuck and remove the stuck wire harness or debris. Check whether the coil is loose or deformed. If so, adjust or replace it in time.

Coil tensioning device failure: check whether the tensioning device loose or damaged, if loose or damaged, timely adjust or replace.

Four, the strand system troubleshooting and maintenance

Stranding irregular: check whether the stranding machine lead is loose or damaged, if loose or damaged, adjust or replace in time; Check whether the strander strander device is loose or deformed. If it is loose or deformed, adjust or replace it in time.

Strander strand is too tight or too loose: Check whether the strander strand device is properly adjusted, and adjust the strander device as required.

Five, troubleshooting and maintenance of safety system

Emergency stop device failure: check whether the emergency stop button is damaged, if damaged, timely replacement; Check whether the circuit of the emergency stop device is normal. If there is an anomaly, repair it in time.

Safety envelope failure: Check whether the safety envelope is placed correctly and confirm whether the envelope blocks the operating area; Check whether the safety light curtain or sensor is working normally. If there is an anomaly, adjust or replace it in time.

The above is a common automatic strander fault elimination and maintenance methods, according to the specific situation of the fault can be targeted inspection and maintenance. During inspection and maintenance, attention should be paid to power off and gas off to ensure the safety of the operator. If the fault persists, contact technical personnel in time.